What are the responsibilities and job description for the Finisher 3rd Shift - 10pm-6:30am position at Fenner, Inc.?
- SAFETY practices MUST be exercised by each operator at all times.
- Use safety devices and equipment provided.
- Refer to shop manual procedures and types of edge finishing.
- Finishers will set rolls on finish table, straighten spirals so they are uniform and connect panels with connecting crimp.
- Once table load is set up, confirm “spirals per foot” from the entry on the shop order.
- Apply tension and trim spirals.
- Square the belt.
- Weld edges of belt in accordance with type of edge required.
- Inspect belt.
- Take belt to shipping department once approved by department supervisor
Equal Opportunity Employer/Protected Veterans/Individuals with Disabilities
This employer is required to notify all applicants of their rights pursuant to federal employment laws. For further information, please review the Know Your Rights notice from the Department of Labor.
