Machine Operator (Take-Off)

PURPOSE

Responsible for packaging materials as it comes off the line and assisting the Line operator thread material through the Line.

PRIMARY DUTIES

• Before beginning work, make sure all guards are in good repair and in the proper locations.
• Communicate with the QC tech for information about each order (number of rolls, bag lengths, number of bags, and special packaging instructions.) Check the Customer Reference Manual for special instructions.
• Restock unwind stand with plastic bags. Put empty cores in trash bin.
• Cut bags for production runs. Keeping tail length to a minimum. Store neatly.
• Doff rolls at the specified length and bag them as designated by the order and take to the scale.
• Bag edge trim and take to the baling area.
• Insert cores when required.
• If necessary, monitor print application and adjust print heads or reposition system if necessary.
• If necessary, monitor wet tack application. Keep the over-waxer clean of oil and replace the cover when not in use.
• If necessary, monitor dry tack application.
• Make recommendations by notifying supervisor, to correct problems that could hinder a machine’s performance, reduce output, or affect quality.
• Make sure material is tracking and knives are cutting correctly. Communicate any problems to the QC Tech or the Line Operator.
• Continuously inspect the material for nonconformance, such as thin spots, trash, tears, color streaking, wet spots, lumps, etc. Inform the QC Tech of any quality problems immediately.
• Assist QC Tech in measuring and checking widths of rolls.
• Always stay accessible to the work area.
• Compare the product being produced to the hand sample.
• Make sure edge trim is kept at a minimal.
• Transfer scrap material to baler.
• Turn bottom sprays on or off when appropriate.
• Keep a clean and orderly workplace. Be responsible for housekeeping around line, tube and plastic storage areas, Brush oven slats when needed. Empty trash receptacles.
• Perform other duties as assigned by department supervisor/lead person.
• Control further processing, delivery or installation of non-conforming product until the deficiency or unsatisfactory condition has been corrected.

POSITION QUALIFICATIONS

• Accuracy Ability to perform work accurate and thoroughly.
• Communication, Oral Ability to communicate effectively with others using the spoken word.
• Problems Solving Ability to find a solution for or to deal proactively with work- related problems
• Working Under Pressure Ability to complete assigned tasks under stressful situations.

SKILLS AND ABILITIES

High School Diploma/GED