Job Description

Job Req ID

28554

Work Type

Onsite

Department

Eaton’s ES GEIS CHD division is currently seeking a NC / CNC Setup & Operate - 3rd Shift. The core hours are 10 : 30 pm to 6 : 30 am.

The hourly rate for this position is 23.99 per hour.

Please note the salary information shown above is a general guideline only. Salaries are based upon candidate skills, experience, and qualifications, as well as market and business considerations.

What you’ll do :

• Plan and perform a wide variety of setups and machining operations on all machine shop equipment, including engine lathe, vertical turret lathe, radial drill press, spindle drill press, shaper, surface grinder, horizontal and vertical milling machines.
• Use all necessary machine attachments, select tools, feeds and speeds according to material and finish requirements.
• Square up and layout production run or special castings for machining operations to fairly close and close tolerances.
• Work with a variety of metals such as steel, iron, brass, bronze and aluminum.
• Layout, machine, fit and assemble jigs and fixtures to facilitate own work.
• Determine operation sequences, make computations for use of dividing head, angles, tapers, fits and assembly.
• Check parts for adequate finish allowance, defective material or faulty operation.
• Maintain equipment, machines and work area in a clean, safe and orderly condition in compliance with 5s processes.

Qualifications :

Required (Basic) Qualifications :

• Must be able to work in the United States without corporate sponsorship now and within the future
• No relocation benefit is being offered for this position. Only candidates within a 50-mile radius of Syracuse, NY will be considered.

Active-Duty Military Service member candidates are exempt from the geographical area limitation.

Last updated : 2024-07-01