The FLANDERS team is looking for Mechanic to join the Casper, WYteam! This over-all Mechanic can disassemble, inspect, clean, repair, test, reassemble basic and routine AC and DC electromechanical motors and equipment. Learn to work in multiple areas but not limited to: Balancing, Machining, Wielding and Winding.

Here's What You'll Learn to Perform Under Supervision.

• Disassembly: Disassemble complex electromechanical equipment noting parts identification, configuration, condition, problems, and failures.
  • Properly mark parts, take photos, and thoroughly complete documentation on iPad, to ensure accurate job completion that meets company and ISO standards.
•  Assembly: Assist level II or III Mechanics with the final assembly of motors per instructions for each specific job
  • Assemble basic to complex motors and equipment including ball, roller, and sleeve bearings.
  • Pre-test electrical, mechanical, and ensure proper lubrication is used per customer/job requirements.
• Testing: Perform basic test of electromechanical equipment and document accordingly. Troubleshoot known or suspected problems.
  • Be aware of any abnormalities in test run (rubbing, noise, end play, brush noise, and commutation, etc.).
• Clean & Inspect: Clean electromechanical equipment assemblies as needed using various methods and steps including but not limited to parts washers/steamers, caustic tanks, and glass beaders.
• Parts Flow Process
• Repairs: Repair or replace defective mechanical or electromechanical parts including but not limited to bearings, brushes, brush holders, motor leads, gears, seals, couplers, overspeeds, brake assemblies and drums, tachs, fans, and end shields.
• Documentation: Maintain thorough documentation on iPad throughout entire repair process, including all test sheets from receiving unit description to Quality Control Checklist. Record accurately and on a timely basis.

Other Areas – Learn to perform under supervision.

• Welding/Fabricating: Assist in welding various pieces of routine/basic equipment and machinery. Learn to create and fabricate basic motor parts and equipment using blueprints. Perform basic and routine welding including Tig, Mig and ARC (stick) welding, and Plasma cutting as needed.
• Balancing: Learn balancing basic/routine rotating equipment including all in house and on-site rotating equipment.
• Winding: Assist on various AC and DC winding jobs including removing original winding, inspecting for winding failure damage, recording data from the original winding, performing voltage testing on standard/basic windings, and assist in rewinding.
• Machining: Learn milling operations such as drilling, tapping, boring, broaching, and conventional milling and lathe work using various engine lathes including but not limited to horizontal and vertical mills and horizontal boring mills.