What are the responsibilities and job description for the Precast Tech position at Fibrebond?
Description
ESSENTIAL FUNCTIONS :
- Lubricates casting machines with oil.
- Positions casting machines over pallet.
- Using overhead bin, distributes concrete and cement into panel form.
- Manually operates screed (straight edge) for leveling concrete.
- Finishes with had trowel around the doors and edges.
- Installs control joint and weld plates.
- Sprays panel with glucose retardant.
- Covers panel with plastic.
- If faux brick is used, uses stencil and coloring for specifications.
- Operates carousel with control panel to move pallets.
- Cleans pallets and forms by removing bulkheads and rails. Buffs bed using an air powered industrial floor buffer. Also, buffs beds by using a straight hoe, hand grinder, and pencil grinder.
- With the assistance of other employees, squares form by positioning and adjusting rails and bulkheads according to blueprints.
- Installs PVCs, foam, and rebar. Glues down applicable components using glue.
- Installs block caps where needed on rails. Covers any holes, openings, or seams on form with tape, etc.
- Installs precut rebar mat.
- Applies grease to bulkheads to keep concrete off. Uses tape, glue, and grease.
- Checks finished product for defects. Pallets are waste high, must climb onto form and bend over to check form. Verifies measurements per print.
- Delivers cut rebar components to precast area from metal fabrication area.
- Prefabricates materials essential to do various processes on carousel line.
- Strips forms on casting beds.
- Attach proper rigging to concrete.
- Once concrete is pulled, remove block outs, and clean edges.
- Bolt pieces together and torque as required.
- Install other components as needed.
Requirements
SKILLS :
REQUIREMENTS :
