• Read and interpret bills of materials (BOM) and blueprints
• Check the parts against the bill of material to confirm that all parts are received and correct; check serial numbers, voltage, phase, etc.
• Assemble units:
  • Mount compressor, condenser, and other components
  • Cut, bend and braze specified tubing to inlets and outlets of components, using proper brazing techniques (nitrogen purging, wet rags, etc.) and following standard DTS procedures
  • Assemble plumbing fittings and thread pipes
  • Cut and Install insulation as specified in BOM
  • Assemble sheet metal cabinet

• Confirm quality
  • Check dimensions of the unit against the prints, i.e. height and width, inlet and outlet, feet, etc.
  • Leak check lines and component connections for leaks
• Observe all company rules and policies, i.e. safety, 5S, attendance
• Participate and work in a team atmosphere
• Maintain high productivity and quality workmanship
• Suggest design and procedure improvements that improve quality, productivity, and reduce cost
• Responsible for keeping work area(s) clean and free of clutter during work time and at the end of shift 5S time

Requirements

• Ability to read, write and do simple math
• Good mechanical ability
• Ability to accurately read tape measure
• Ability to read and interpret blueprints and bills of material
• Ability to braze / silver solder copper and stainless steel piping to DTS standards
• Ability to bend and form copper tubing to DTS standards

• Ability to safely and properly use a wide variety of shop tools, including hand and power tool
• Ability to work cooperatively with others in a team environment
• Ability to follow directions in standard practices and procedures